Chapter 5: Advanced Serverboard Setup Trusted Platform Module Header This header is used to connect a Trusted Platform Module (TPM), available sepa- rately from a third-party vendor. A TPM is a security device that allows encryption and authentication of hard drives, disal- lowing access if the TPM associated with it is not installed in the system. See the table on the right for pin defi nitions. IPMB A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate cable here to use the IPMB I 2 C connection on your system. Power Supply I 2 C Connector The Power Supply (I 2 C) connector is located at JPI 2 C1 on the serverboard.
This connector monitors the status of the power supply, fan and system tempera- ture. See the table on the right for pin defi nitions. Wake-On-LAN The Wake-On-LAN header is located at JSTBY1 on the serverboard. See the table on the right for pin defi nitions.
(You must also have a LAN card with a Wake-On-LAN connector and cable to use this feature.) 5-17 Trusted Platform Module Header Pin Defi nitions Pin # Defi nition Pin # Defi nition 1 LCLK 2 GND 3 LFRAME 4 No Pin 5 LRESET 6 VCC5 7 LAD3 8 LAD2 9 VCC3 10 LAD1 11 LAD0 12 GND 13 RSV0 14 RSV1 15 SB3V 16 SERIRQ 17 GND 18 CLKRUN 19 LPCPD 20 RSV2 IPMB Header Pin Defi nitions Pin# Defi nition 1 Data 2 Ground 3 Clock 4 No Connection PWR Supply I2C Pin Defi nitions Pin# Defi nition 1 Clock 2 Data 3 PWR Fail 4 Ground 5 3.3V Wake-On-LAN Pin Defi nitions (JWOL) Pin# Defi nition 1 +5V Standby 2 Ground 3 Wake-up