Chapter 5: Advanced Serverboard Setup 5-4 Installing Memory CAUTION! Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. ! Memory Support The X8DTT-H series serverboard supports up to 192 GB of Registered ECC or 48 GB of Unbuffered ECC/Non-ECC DDR3 1333 MHz/1066 MHz/800 MHz in 12 DIMM slots. Note : Check the Supermicro web site for recommended DIMMs. Installing Memory Modules Insert each memory module vertically into a slot following the charts below. 1. Pay attention to the notch along the bottom of the module to prevent inserting it incorrectly. Gently 2. press down on the DIMM until it snaps into place in the slot (see Figure 5-2).
Repeat for all DIMMs. See tables below and on following pages. 3. 5-7 Populating Memory for Optimal Performance (Single CPU Confi guration) Branch 0 Branch 1 Branch 2 3 DIMMs P1 DIMM1A P1 DIMM2A P1 DIMM3A 6 DIMMs P1 DIMM1A P1 DIMM1B P1 DIMM2A P1 DIMM2B P1 DIMM3A P1 DIMM3B Populating Memory for Optimal Performance (Dual CPU Confi guration) CPU1 CPU2 Branch 0 Branch 1 Branch 3 Branch 0 Branch 1 Branch 3 6 DIMMs 1A 2A 3A 1A 2A 3A 12 DIMMs 1A 1B 2A 2B 3A 3B 1A 1B 2A 2B 3A 3B