Chapter 5: Advanced Serverboard Setup Front Panel Accessible Add-on Card Header (JF2) The JF2 add-on card header provides front access to the power supply, Serial ATA and control panel connections for the X8DTT-H+ series motherboard. Plug an add-On card into this header to use the functions indicated above. This header is designed specifi cally for Supermicro-proprietary add-on cards. System Reset If System Reset (JRST1) is connected to a switch, then the system reset feature is enabled. See the table on the right for pin defi nitions. Unit Identifi er Switches Two Unit Identifi er (UID) switches and LED indicators are located on the serverboard.
The Front Panel UID Switch is located at pin 16 on JF2. The Rear UID Switch is located at SW1 next to the Infi niBand Connector. The Front Panel UID LED is located at pin 17 of JF2, and the Rear UID LED is located at LE4. When you press the UID switch on the front panel or on the back panel, both Rear UID LED and Front Panel UID LED indicators will be turned on. Press the UID switch again to turn off both LED Indicators. These UID Indi- cators provide easy identifi cation of a system unit that may be in need of service. See the table on the right for pin defi nitions. Note : UID LED is supported by the physical switch or the BMC. When it is controlled by the physical switch, it will stay solid.
When it is controlled by the BMC, it will blink. 5-15 Alarm Reset Pin Defi nitions Pin# Defi nition 1 3.3V 2 Ground UID Switch Pin Defi nitions Pin# Defi nition 1 Ground 2 Ground 3 Button In 4 Ground UID Switches & LEDs Description Location FP Switch Pin 16 on JF2 Rear Switch SW1 FP UID LED (Blue LED) Pin 17 on JF2 Rear UID LED LE4