SUPERSERVER 2026TT-DLRF/DLIBXRF/DLIBQRF User's Manual 5-8 Jumper Settings Connector Pins 3 2 1 To modify the operation of the serverboard, jumpers can be used to choose between optional settings. Jumpers create shorts be- tween two pins to change the function of the connector. Pin 1 is identifi ed with a square solder pad on the printed circuit board. See the serverboard layout pages for jumper locations. Jumper 3 2 1 Setting Note: On a two-pin jumper, "Closed" means the jumper is on both pins and "Open" means the jumper is either on only one pin or com- pletely removed. CMOS Clear JBT1 is used to clear CMOS (which will also clear any passwords).
Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS. To Clear CMOS First power down the system and unplug the power cord(s). 1. With the power disconnected, short the CMOS pads with a metal object such 2. as a small screwdriver. Remove the screwdriver (or shorting device). 3. Reconnect the power cord(s) and power on the system. 4. Note: Do not use the PW_ON connector to clear CMOS. 5-16