Supermicro — 2028TP-DECR-DECTR-DECFR_1.0.indb

SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual Support Aggressive Link Power Management When this item is set to Enabled, the SATA AHCI controller manages the power usage of the SATA link. The controller will put the link to a low power state when the I/O is inactive for an extended period of time, and the power state will return to normal when the I/O becomes active. The options are Enabled and Disabled. sSATA RAID Option ROM/UEFI Driver Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for system boot. The options are Disabled, EFI , and Legacy.

sSATA Port 0~ Port 3 This item displays the information detected on the installed sSATA drives on the particular sSATA port. Model number of drive and capacity Software Preserve Support Select Enabled to enable an sSATA port specifi ed by the user. The options are Disabled and Enabled. sSATA Port 0~ Port 3 sSATA Port 0 ~ Port 3 Hot Plug This feature designates this port for hot plugging. Set this item to Enabled for hot-plugging support, which will allow the user to replace an sSATA drive without shutting down the system. The options are Enabled and Disabled .

sSATA Port 0 ~ Port 3 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRESET initialization to the device. The options are Enabled and Disabled . Port 0 ~ Port 3 sSATA Device Type Use this item to specify if the sSATA port specifi ed by the user should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. 7-22