Chapter 5: Advanced Serverboard Setup Unit Identifi er Switch A Unit Identifi er (UID) switch (SW1) and an LED indicator are located to the right of the VGA port. When the user presses the UID switch, the UID indicator will be turned on. Press the UID switch again to turn off the UID LED. The UID indication provides easy identifi cation of a system unit that may be in need of service. A System Management Bus header for the IPMI slot is located at JIPMB1. Connect an appropriate cable here to use the IPMB I 2 C connection on your system. IPMB I 2 C SMB Fan Headers This serverboard has two system fan headers (Fan 3/Fan 4).
These 4-pin fans headers are backward compatible with traditional 3-pin fans. However, fan speed control is available for 4-pin fans only. The fan speeds are controlled by Thermal Management via the IPMI 2.0 interface. See the table on the right for pin defi nitions. DOM Power Connector A power connector for SATA DOM (Disk On Module) devices is located at JSD1. Connect an appropriate cable here to provide power for your SATA DOM devices. SATA DOM + Power Conection A SATA DOM with power-pin is located at S-SATA3. Install a SATA device here to use onboard SATA connections, which are supported by the Intel PCH.
5-15 SMB Header (JIPMB1) Pin Defi nitions Pin# Defi nition 1 Data 2 Ground 3 Clock 4 No Connection Fan Header (Fan3/4) Pin Defi nitions Pin# Defi nition 1 Ground 2 +12V 3 Tachometer 4 PWR Modulation DOM PWR (JSD1) Pin Defi nitions Pin# Defi nition 1 +5V 2 Ground 3 Ground