Supermicro — 2028TP-DECR-DECTR-DECFR_1.0.indb

SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual Installing a Drive into the Hard Drive Tray The drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also help promote proper airfl ow for the drive bays. 1. Remove the screws (4) holding connecting the drive tray the carrier. 2. Remove the tray from the carrier. 3. Install a new drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 4. Secure the hard drive by tightening all four (4) screws. 5. Use the open handle to replace the drive carrier into the chassis. Make sure to close the drive carrier handle.

Figure 6-18. Chassis Drive Tray Dummy Drive Hard Drive Carrier Warning: Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers. For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/products/nfo/fi les/ storage/SAS-CompList.pdf 6-16