Chapter 5: Advanced Motherboard Setup Trusted Platform Module Header This header is used to connect a Trusted Platform Module (TPM), available sepa- rately from a third-party vendor. A TPM is a security device that allows encryption and authentication of hard drives, disal- lowing access if the TPM associated with it is not installed in the system. See the table on the right for pin defi nitions. Onboard Power LED An onboard Power LED header is lo- cated at JLED. This Power LED header is connected to the Control Panel header (JF1) to indicate the status of system power. See the table on the right for pin defi nitions.
Power Supply I 2 C Connector The Power Supply (I 2 C) connector is located at JPI 2 C on the motherboard. This connector monitors the status of the power supply, fan and system tempera- ture. See the table on the right for pin defi nitions. Wake-On-LAN The Wake-On-LAN header is located at JWOL on the motherboard. See the table on the right for pin definitions.
Wake-On-LAN Pin Defi nitions (JWOL) Pin# Defi nition (You must also have a LAN card with a Wake-On-LAN connector and cable to use this feature.) 1 +5V Standby 2 Ground 3 Wake-up 5-17 Trusted Platform Module Header Pin Defi nitions Pin # Defi nition Pin # Defi nition 1 LCLK 2 GND 3 LFRAME 4 No Pin 5 LRESET 6 VCC5 7 LAD3 8 LAD2 9 VCC3 10 LAD1 11 LAD0 12 GND 13 RSV0 14 RSV1 15 SB3V 16 SERIRQ 17 GND 18 CLKRUN 19 LPCPD 20 RSV2 Onboard PWR LED Pin Defi nitions Pin# Defi nition 1 VCC 2 No Connection 3 Connection to PWR LED in JF1 PWR Supply I2C Pin Defi nitions Pin# Defi nition 1 Clock 2 Data 3 PWR Fail 4 Ground 5 3.3V