S UPER S ERVER 5017C-TF User's Manual PCI Slot SMB Enable Use Jumpers JI 2 C1/JI 2 C2 to enable PCI SMB (System Management Bus) support to improve system management for the PCI slots. Default is disabled. See the table on the right for jumper settings. LAN Port Enable/Disable Use JPL1/JPL2 to enable or disable LAN Ports 1 and 2 on the motherboard. See the table on the right for jumper settings. The default setting is enabled. USB Wake-Up Use the JPUSB1 jumper to wake your system by pressing a key on a USB keyboard or clicking USB mouse. This jumper is used together with the USB Wake-Up feature in the BIOS.
Enable this jumper and the USB feature in the BIOS to wake-up your system via USB devices. The default setting is enabled. BMC Enable/Disable JPB is used to enable or disable the BMC (Baseboard Management Control) chip and the onboard IPMI connection. This jumper is used together with the IPMI set- tings in the BIOS. The default position is on pins 1 and 2 to Enable BMC. See the table on the right for jumper settings. Watch Dog Enable Watch Dog is a system monitor that can reboot the system when a software ap- plication hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate a non-maskable interrupt signal for the application that hangs.
See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS. 5-20 PCI Slot SMB Enable/Disable Jumper Settings Jumper Setting Defi nition Closed Enabled Open (Default) Disabled LAN Port En/Disable Jumper Settings Pin# Defi nition 1-2 Enabled 2-3 Disabled USB Wake-up Jumper Settings Pin# Defi nition 1-2 Enabled (Default) 2-3 Disabled BMC IPMI Enable/Disable Jumper Settings Settings Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Defi nition Pins 1-2 Reset (default) Pins 2-3 NMI Open Disabled