S UPER S ERVER 5017C-TF User's Manual SATA power cables should be routed so that they do not block the airfl ow through the chassis. See the serverboard layout diagram for the location of the cable con- nections. Serial ATA Power Cables DVD-ROM Drive Installation The top cover of the chassis must be opened to gain full access to the DVD-ROM drive bay. The DVD-ROM drive must have a "slim" profi le to fi t into the 5017C-TF. Installing a DVD-ROM Drive Power down the system and remove the AC power cord. 1. Release the retention screws that secure the unit to the rack. 2. Grasp the two handles on either side and pull the unit straight out until it 3. locks (you will hear a "click").
Depress the two buttons on the top of the chassis to release the top cover 4. and at the same time, push the cover away from you until it stops. You can then lift the top cover from the chassis to gain full access to the inside of the server. Note: Drives mount on rails and should "click" into place to be correctly and fully installed in their bays. A red mark on a wire typically designates the location of pin 1. 6-6