Supermicro SuperServer 5017C-TF — Supermicro SuperServer 5017C-TF User's Manual PDF Download

Chapter 6: Advanced Chassis Setup 6-5 Power Supply The 5017C-TF has a single 350 watt power supply. This power supply has the capability of operating at 100 or 240 input volts. Use the main power button on the front of the chassis to power off the system and then unplug the AC power cord before removing the power supply for any reason. Power Supply Failure If the power supply unit fails, the system will shut down and you will need to replace the power supply unit. Replacement units can be ordered directly from Supermicro (see part numbers in the appendix and contact infomation in Chapter 1). Replacing the Power Supply Unplug the AC power cord. 1.

Remove the top chassis cover (see procedure on previous page). 2. Remove the two screws on the back of the power supply, which secure it to 3. the chassis. You can then lift the unit straight out of the chassis. Replace the failed unit with another unit of the same wattage. 4. Carefully insert the new unit into position in the chassis and secure it with the 5. two screws at the rear of the unit. Before reconnecting the power cord, make sure the power switch on the 6. power supply is in the off position. Reconnect the power cord, replace the chassis top cover and push the unit 7. back into the rack. Finish by turning the power switch on the power supply on, and then depress 8.

the power button on the front of the system. 6-7