Supermicro SuperServer 5019S-ML — Explanation of Jumpers

Chapter 4: Motherboard Connections SuperServer 5019S-ML User's Manual VGA Enable/Disable BIOS Recovery JPG1 allows you to enable or disable the VGA port. The default setting is Enabled. Use jumper JBR1 to recover the BIOS settings on the motherboard. The default setting is Normal. SMBus to PCI Slots LAN1/2 Enable/Disable Use jumpers JI 2 C1 and JI 2 C2 to connect the System Management Bus (I2C) to PCI-Express slots to improve PCI performance. These two jumpers should be set to the same setting. The default setting is Disabled. Change the setting of jumper JPL1 and JPL2 to enable or disable the LAN1 and LAN2 Ethernets ports, respectively. The default setting is Enabled.

BMC Enabled Jumper JPB1 allows you to enable the embedded ASpeed AST2400 Baseboard Management Controller (BMC) to provide IPMI 2.0/KVM support on the motherboard. The default setting is BMC Enable. Watch Dog JWD controls the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note: When Watch Dog is enabled, the user needs to write their own application software to disable it.

Manufacturer Mode Select Close pins 2 and 3 of jumper JPME2 to bypass SPI flash security and force the system to operate in the manufacturer mode, which will allow the user to flash the system firmware from a host server for system setting modifications. The default setting is Normal.

53 52 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled BIOS Recovery Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 BIOS Recovery I2C for PCI-E Slots Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled LAN1/2 Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled BMC Enable Jumper Settings Jumper Setting Definition Pins 1-2 BMC Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled Manufacturer Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 Manufacturer Mode