Chapter 4: Motherboard Connections Chapter 4 Motherboard Connections This section describes the connections on the motherboard and provides pinout definitions. Note that depending on how the system is configured, not all connections are required. The LEDs on the motherboard are also described. A motherboard layout indicating component locations may be found in Chapter 1. Please review the safety precautions in Appendix B before installing or removing components. 4.1 Motherboard Sled I/O Ports and Controls 7 5 1 8 6 4 3 2 Power Button The power control button (SW1) on each motherboard sled is described in Chapter 1.
KVM/VGA Connector This KVM/VGA (UART) connector provides console redirection support or a remote networking interface. Using the adapter it provides two USB ports (USB0/1), a COM port and a VGA port. KVM Switch/Indicator The KVM switch (shown in Figure 1-3) toggles the KVM connector signal between the pair of nodes on the motherboard. The switch is integrated with an LED indicator. When the indicator is green, the KVM port is linked to node 1; when it is orange, the KVM port is linked to node 2. IPMI Port A LAN port is a dedicated connection for IPMI. 37 I/O Ports # Description # Description 1. Power Switch 5. P2 LAN1 2. KVM Connector 6. P1 LAN1 3. KVM signal switch/LED 7. P2 LAN2 4.
IPMI LAN 8. P1 LAN2