Supermicro 5038MD-H24TRF — Supermicro SuperServer 5038MD-H24TRF User's Manual PDF

SuperServer 5038MD-H24TRF User's Manual VGA Enable/Disable Close pins 2 and 3 of jumper P1-JPG1 (node 1) or P2-JPG1 (node 2) to disable the onboard VGA port using the onboard graphics controller. The default setting is Enabled. Watch Dog P1-JWD1 (for Node 1) or P2-JWD1 (for Node 2) control the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note:

When Watch Dog is enabled, the user must write their own application software to disable it. BIOS Recovery Jumper JBR1 is used to recover the BIOS settings on the motherboard (P1-JBR1 for Node 1, P2-JBR1 for Node 2). The default setting is Normal. 40 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled BIOS Recovery Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 BIOS Recovery