Supermicro 5038MD-H8TRF — Supermicro SuperServer 5038MD-H8TRF User's Manual (Revision 1.0) PDF

SuperServer 5038MD-H8TRF User's Manual VGA Enable/Disable Close pins 2 and 3 of jumper JPG1 to disable the onboard VGA port using the onboard graphics controller. The default setting is Enabled. SMBus to PCI Slots Use jumpers JI 2 C1 and JI 2 C2 to connect the System Management Bus (I 2 C) to PCI-E slots to improve PCI performance. Both jumpers must be set to the same setting. (JI 2 C1 controls the clock and JI 2 C2 controls the data.) The default setting is Disabled. Management Engine (ME) Recovery Use jumper JPME1 to select ME Firmware Recovery mode, which will limit resource allocation for essential system operation only in order to maintain normal power operation and management.

In the single operation mode, online upgrade will be available via Recovery mode. See the table below for jumper settings. Manufacturer Mode Select Close pin 2 and pin 3 of jumper JPME2 to bypass SPI flash security and force the system to operate in the manufacturer mode, which will allow the user to flash the system firmware from a host server for system setting modifications. The default setting is Normal.

48 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled I2C to PCI-E Slots Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Manufacturer Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 ME Recovery Manufacturer Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal (Default) Pins 2-3 Manufacturer Mode