Supermicro 5038MD-H8TRF — Supermicro SuperServer 5038MD-H8TRF User's Manual (Revision 1.0) PDF

Chapter 4: Motherboard Connections Watch Dog JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note: When Watch Dog is enabled, the user must write their own application software to disable it. M.2 I 2 C Header A System Management Bus header for the M.2 sockets is located at JP2. Connect the appropriate cable here to use the M.2 I 2 C connection on your system.

Refer to the table below for pin definitions. Hard Drive Backplane Selection Use jumper J5 to set whether a SATA hard drive or a SAS hard drive is being used with your system. 49 Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled SMBus to M.2 Pin Definitions Jumper Setting Definition Pins 1-2 Enable Pins 2-3 Disable Hard Drive Backplane Selection Pin Definitions Jumper Setting Definition Pins 1-2 SATA Pins 2-3 SAS