Supermicro SuperServer 6040 — Supermicro SuperServer 6040 User's Manual PDF – 4U Dual Processor Server Guide

S UPER S ERVER 6040 Manual 5-7 Connector Definitions Table 5-1 ATX Power Supply Connector Pin Definitions Power Supply Connector After you have mounted the moth- erboard and added memory and PCI cards, you are ready to con- nect the cables. Attach an ATX power supply cable to ATX #1 and also to ATX#2 (for heavy load configurations. See Table 5-1 for the pin definitions of these ATX power supply connectors. Table 5-2 Secondary Power Connector (PWR_SEC) Secondary Power Connector Use of the secondary power con- nector (PWR_SEC) is recom- mended when a heavy load of pe- ripherals has been added to the motherboard. Note:

Be sure to use a 6- pin connector and check the power supply lay- out before attaching it. See Table 5-2 for pin definitions. Power LED Table 5-3 PWR_LED Pin Definitions (JF1) The Power LED connection is lo- cated on pins 1, 3 and 5 of JF1. See Table 5-3 for pin definitions and Figure 5-2 for pin locations. Hard Drive LED Table 5-3a IDE_LED Pin Definitions (JF1) The Hard Drive LED connection is located on JF1. Attach the IDE hard drive LED cable to the cor- rect pins to display disk activity. See Table 5-3a for pin definitions (370DE6).

5-12 Pin Number Definition Pin Number Definition 1 3.3V 2 3.3V3 3 Ground 4 5V 5 Ground 6 5V 7 Ground 8 PW-OK 9 5VSB 10 12V 11 3.3V 12 -12V 13 Ground 14 PS-ON 15 Ground 16 Ground 17 Ground 18 -5V 19 5V 20 5V Pin Number Definition 1 2 3 4 5 6 Ground Ground Ground +3.3V +3.3V +5V (keyed) Pin Number Definition 1 3 5 PWR/Control Key GND Pin Number Definition 7 9 +5V HD Active