S UPER S ERVER 6040 Manual Third Power Supply Failure Alarm Enable/Disable (*For Supermicro's Hot-Swap Triple Redundant Power Supplies only) Table 5-24 Power Supply Failure Alarm Enable/Disable Jumper Settings (JP55) The system will notify you in the event of a power supply failure. This feature assumes that three power supply units are installed in the chassis, with one acting as a backup. If you only have one or two power supply units installed, you should disable this with JP55 to prevent false alarms. See Table 5-24 for jumper settings.
SCSI Termination Enable/ Disable Table 5-25 SCSI Termination Enable/Disable Jumper Settings (JP60) The SCSI Termination jumper (JP60) allows you to enable or disable termination for the SCSI connectors. The normal (default) position is open to enable SCSI termination. See Table 5-25 for jumper settings. SpeakerEnable/Disable Table 5-26 Speaker Enable/Disable Jumper Settings (JP56) You may want to disable the onboard speaker. Jumper JP56 gives you this option. See Table 5-26 for jumper settings. 5-20 Jumper Position Definition Open Closed Disabled Enabled Jumper Position Definition Open Closed Enabled Disabled Jumper Position Definition Open Closed Disabled Enabled