Supermicro SuperServer 6040 — Supermicro SuperServer 6040 User's Manual PDF – 4U Dual Processor Server Guide

Chapter 5: Advanced Motherboard Setup Core/BUS Ratio of 5.5. After determining the CPU Core/ Bus Ratio, refer to Table 5-22 for the correct settings of DIP SW 1. *Note: Most Intel Processors have a fixed Core/Bus ratio that will overwrite the setting of DIP SW1. 5-9 Jumper Settings Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the motherboard, jumpers can be used to choose between optional set- tings. Jumpers create shorts be- tween two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for 3 2 1 Jumper Cap Pin 1-2 short Setting jumper locations.

CMOS Clear Table 5-23a CMOS Clear Jumper Settings (JBT1) Refer to Table 5-23a for the jumper set- tings to clear CMOS. Always remove the AC power cord from the system before clearing CMOS. NOTE: For an ATX power supply, Jumper Position 1-2 2-3 Definition Normal CMOS Clear you must completely shut down the system, remove the Position 1-2 Position 2-3 AC power cord and then use JBT1 to clear CMOS. Re- place JBT1 back to the pin 1-2 position before power- Normal CMOS Clear ing up the system again. Do not use the PW_ON con- nector to clear CMOS. Front Side Bus Speed Table 5-23b Jumper Settings (JP1) The JP1 jumper sets the FSB speed.

Since the 370DE6 only runs at a 100 MHz front side bus speed, you do not need to change this setting. Table 5-23b de- scribes the jumper settings. * Note: The Auto setting allows the CPU to set the speed. 5-19 Jumper Position Definition 1-2 2-3 OFF Auto 100 MHz 133 MHz