Supermicro 8048B-TRFT — SuperServer 8048B-TRFT User's Manual

Chapter 5: Advanced Serverboard Setup 5-4 Processor and Heatsink Installation Warning: When handling the processor package, avoid placing direct pressure on the label area. Notes: Always connect the power cord last, and always remove it before adding, removing or changing any hardware components. Make sure that you install the processor into the CPU socket before you install the CPU heatsink. If you buy a CPU separately, make sure that you use an Intel-certified multi- directional heatsink only. Make sure to install the system board into the chassis before you install the CPU heatsink.

When receiving a server board without a processor pre-installed, make sure that the plastic CPU socket cap is in place and none of the socket pins are bent; otherwise, contact your retailer immediately. Refer to the Supermicro website for updates on CPU support. When one CPU is installed, be sure to installed to CPU Socket 1 first. Installing the Processors 1. There are two load levers on the LGA2011 socket. To open the socket cover, first press and release the load lever labeled 'Open 1st'. OPEN 1st OPEN 1st Press down on load lever labeled 'Open 1st'. Note: There are four CPU sockets located on the X10QBi baseboard.

Populate the desired number of CPUs on the board starting with CPU Socket 1. 5-5