Supermicro 8048B-TRFT — SuperServer 8048B-TRFT User's Manual

SUPERSERVER 8048B-TRFT USER'S MANUAL 5-5 Installing Memory Caution: exercise extreme care when installing or removing DIMMs to prevent any possible damage. DIMMs should be installed with the memory card removed from the baseboard. See the tables on page 5-12 for details on populating RDIMM/LDIMM memory. Installing Memory Insert the desired number of DIMMs into the slots on a memory card in the order shown in Figure 5-4. For best performance, use the memory modules of the same type and speed. 1. Push the release tabs outwards on both ends of the DIMM slot to unlock it. 2. Align the key of the DIMM module with the receptive point on the memory slot. 3.

Press both ends of the module straight down into the slot until the module snaps into place. 4. Press the release tabs to the locking positions to secure the DIMM module into the slot. 5. Reverse the steps above to remove DIMM modules. Memory Support With all eight cards fully populated, the system will support up to a total of 6 TB of DDR3-1600/1333/1066/800 ECC RDIMM/LDIMM memory. Check the Supermicro website ( www.supermicro.com ) for the latest memory support information. Figure 5-4.

X10QBi-MEM1 Memory Card Layout A3 D1 D2 C1 C2 C3 D3 OK B1 B2 B3 A1 A2 D3 D2 1 D6 5 D4 D1 1 PRESENT LEDs 8 7 4 3 2 DIMMA1 DIMMA2 DIMMA3 DIMMB3 DIMMB2 DIMMB1 DIMM B3 DIMM B2 DIMM B1 DIMMC2 DIMMC1 DIMMD3 DIMMD2 DIMMD1 DIMM C3 DIMM C2 DIMM C1 DIMM D3 DIMM D2 DIMM D1 DIMM A1 DIMM A3 DIMM A2 DIMMC3 JDI JDI BAR CODE X10QBi-MEM1 Rev. 1.01 Notes : When installing a DIMM module, be sure to press the module straight down into the slot until it is properly seated and its PRESENT LED (as shown above) turns on. 5-10