Chapter 5: Advanced Serverboard Setup 5-9 Connector Definitions Power Connectors A 24-pin main power supply connector (JPW1) and six 8-pin power connectors (JPW2-JPW7) are located on the X10DBi serverboard. These power connectors meet the SSI EPS 12V specification. Connect these power connectors to your power supply to provide adequate power to your system. Refer to the table on the right for pin definitions. (Required) Warning : To provide adequate power supply to the system, the 24-pin ATX PWR (JPW1) and all six 8-pin power connectors (JPW2-JPW7) must be connected to the power supply. Failure to do so will void the manufacturer warranty on your power supply and serverboard.
DOM Power Connector A power connector for SATA DOM (Disk- On-Module) devices is located at JSD1. Connect the appropriate cable here to provide power support for your SATA DOM devices. 5-17 ATX Power 24-pin Connector Pin Definitions Pin# Definition Pin # Definition 13 +3.3V 1 +3.3V 14 -12V 2 +3.3V 15 COM 3 COM 16 PS ON _ 4 +5V 17 COM 5 COM 18 COM 6 +5V 19 COM 7 COM 20 Res (NC) 8 PWR OK _ 21 +5V 9 5VSB 22 +5V 10 +12V 23 +5V 11 +12V 24 COM 12 +3.3V 12V 8-pin Power Connector Pin Definitions Pins Definition 1 through 4 Ground 5 through 8 +12V DOM PWR Pin Definitions Pin# Definition 1 +5V 2 Ground 3 Ground