Supermicro 8048B-TRFT — SuperServer 8048B-TRFT User's Manual

Chapter 5: Advanced Serverboard Setup Power LED/Speaker On the JD1 header, pins 1-3 are used for power LED indication, and pins 4-7 are for the speaker. See the tables on the right for pin definitions. Please note that the speaker connector pins (4-7) are for use with an external speaker. If you wish to use the onboard speaker, close pins 6-7 with a cap. Overheat LED/Fan Fail The JOH1 header is used to connect an LED indicator to provide warnings of chas­ sis overheating or fan failure. This LED will blink when a fan failure occurs. Refer to the table on right for pin definitions.

Power SMB (I 2 C) Connector The Power System Management Bus (I 2 C) connector (JPI 2 C1) is used to monitor onboard power supply, fan and system temperatures. Refer to the table on the right for pin definitions. IPMB A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate cable here to use the IPMB I 2 C connection for your system.

5-23 PWR LED Connector Pin Definitions Pin Setting Definition Pin 1 Anode (+) Pin2 Cathode (-) Pin3 NA Speaker Connector Pin Settings Pin Setting Definition Pins 4-7 External Speaker Pins 6-7 Internal Speaker Overheat LED Pin Definitions Pin# Definition 1 5vDC 2 OH Active OH/Fan Fail LED Status State Message Solid Overheat Blinking Fan Fail PWR SMB Pin Definitions Pin# Definition 1 Clock 2 Data 3 PMBUS Alert _ 4 Ground 5 +3.3V IPMB Header Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection