Supermicro SuperServer 8060 — Supermicro SuperServer 8060 User Manual PDF – 4U Quad Xeon Server Guide

S UPER S ERVER 8060 Manual For grounding purposes, make sure your computer chassis provides ex- cellent conductivity between the power supply, the case, the mounting fasteners and the motherboard. Unpacking The motherboard is shipped in antistatic packaging to avoid static electrical damage. When unpacking the board, make sure the person handling it is static protected. 5-2 Motherboard Installation This section explains the first step of physically mounting the S2QE6 into the SC860 chassis. Following the steps in the order given will eliminate the most common problems encountered in such an installation. To remove the motherboard, follow the procedure in reverse order. 1.

Accessing the inside of the 8060 (see Figure 2-5): First, release the two retention screws that secure the unit to the rack. Grasp the two handles on either side and pull the unit straight out. Next, release the two screws that secure the top cover to the chassis. Remove the top chassis cover by pushing forward on the cover recesses until it stops. Lift the cover from the chassis. You should now have full access to the inside of the server. 2. Installing metal standoffs and rubber feet: With the chassis opened up, the motherboard tray is directly in front of you. First, check that the location of all the mounting holes on both the motherboard and the tray match.

Refer to Figure 5-1 for mounting hole locations. Attach metal standoffs to the holes labeled "Q" on the motherboard tray. Make sure these metal standoffs either click in or are screwed in tightly. There are eight additional square metal standoffs that are required for mounting the DRMs (Dual Retention Modules), which should be preinstalled. Several square rubber "feet" must be applied to the motherboard tray to function as shock absorbers. Attach these feet to the small square outlines on the tray. 3. Check compatibility of motherboard ports and I/O shield: The S2QE6 requires a chassis big enough to support a 13" x 18" 5-2