S UPER S ERVER 8060 Manual 5-3 Connecting Cables Now that the motherboard is installed, the next step is to connect the cables to the board. These include the data (ribbon) cables for the peripherals and front control panel, the power fail signal (PWR P) cable and the power cables. Connecting Data Cables The ribbon cables used to transfer data from the peripheral devices have been carefully routed to prevent them from blocking the flow of cooling air that moves through the system from front to back. If you need to disconnect any of these cables, you should take care to keep them routed as they were originally after reconnecting them (make sure the red wires connect to the pin 1 locations).
The following data cables (with their locations noted) should be con- nected. (See the layout on page 5-12 for connector locations.) l IDE Device Cables (J13 and J14) l Floppy Drive Cable (J15) l SCSI Device Cables (JA1, JA3 and JA5) l Control Panel Cable (JF1, see next page) l Power Fail Signal Cable (PWR P) Connecting Power Cables The S2QE6 has two primary power supply connectors: ATX Power #1 and ATX Power #2. You must connect both the primary and the secondary ATX power connectors to your power supply. See the layout on page 5-12 for connector locations. 5-4