Chapter 5: Advanced Motherboard Setup Connecting the Control Panel The JF1 header on the S2QE6 contains header pins for various control panel connectors. See Figure 5-2 for the locations of the speaker, overheat LED, keyboard lock, chassis intrusion, I2C, network activity LED, power fail, fan fail, 5v standby, power LED, IDE drive activity LED, power on LED, reset switch, USB0 and alarm reset headers. Note that even and odd numbered pins are on opposite sides of the connector. All JF1 wires have been bundled into a single ribbon cable to simplify this connection. Make sure the red wire plugs into pin 1 as marked on the board.
The other end connects to JP9 of the Control Panel PCB board, located just behind the system status LEDs on the chassis. See pages 5-14 to 5-18 for details and pin descriptions. Figure 5-2. Control Panel Connectors 34 33 Alarm Reset Speaker USB0 Overheat LED Keyboard Lock Chassis Intrusion Key I2C Reset NLED PWR_ON PFL IDE LED FFL PWR_LED 5SB 2 1 JF1 5-5