S UPER S ERVER 8060 Manual SCSI Enable/Disable Table 5-31 SCSI Enable/Disable Jumper Settings (JA7) Jumper JA7 allows you to enable or disable all onboard SCSI. The normal (default) position is open to enable SCSI operation. See Table 5-31 for jumper settings. CMOS Clear Table 5-32 CMOS Clear Jumper Settings (JBT1) Refer to Table 5-32 for setting JBT1 to clear CMOS. Always re- move the AC power cord from the system before clearing CMOS. 5-10 Port/Control Panel Connector Locations The I/O ports on the S2QE6 are color coded in conformance with the PC 99 specification. These should be the last connections you make on the moth- erboard before you can apply power.
See Figure 5-8 below for the colors and locations of the various I/O ports. Figure 5-8. I/O Port Locations and Definitions Mouse (Green) Parallel Port (Burgundy) Ethernet Port (Black) COM1 Port (Turquoise) Keyboard (Purple) USB Ports (Black) VGA Graphics Port (Blue) Note: COM2 Port is a header on the motherboard, located near the mouse/keyboard ports. 5-24 Jumper Position Definition Open Closed Enabled Disabled Jumper Position Definition 1-2 2-3 Normal CMOS Clear