Chapter 5: Advanced Motherboard Setup 5-11 Parallel Port, Floppy/Hard Disk Drive and SCSI Connections Use the following information to connect the floppy and hard disk drive cables. The floppy disk drive cable has seven twisted wires. A red mark on a wire typically designates the location of pin 1. A single floppy disk drive ribbon cable has 34 wires and two connectors to provide for two floppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B.
Table 5-33 Parallel (Printer) Port Pin Definitions (J16) Parallel Port Connector The parallel port is located on J16 and requires a 26-pin ribbon cable for operation. See Table 5-33 for pin definitions. Floppy Connector Table 5-34 Floppy Connector Pin Definitions (J15) The floppy connector is located on J15 and requires a 34-pin rib- bon cable for operation. See Table 5-34 for pin definitions.
5-25 Pin Number Function Pin Number Function 1 Strobe- 3 Data Bit 0 5 Data Bit 1 7 Data Bit 2 9 Data Bit 3 11 Data Bit 4 13 Data Bit 5 15 Data Bit 6 17 Data Bit 7 19 ACK 21 BUSY 23 PE 25 SLCT 2 Auto Feed- 4 Error- 6 Init- 8 SLCT IN- 10 GND 12 GND 14 GND 16 GND 18 GND 20 GND 22 GND 24 GND 26 NC Pin Number Function Pin Number Function 1 GND 3 GND 5 Key 7 GND 9 GND 11 GND 13 GND 15 GND 17 GND 19 GND 21 GND 23 GND 25 GND 27 GND 29 GND 31 GND 33 GND 2 FDHDIN 4 Reserved 6 FDEDIN 8 Index- 10 Motor Enable 12 Drive Select B- 14 Drive Select A- 16 Motor Enable 18 DIR- 20 STEP- 22 Write Data- 24 Write Gate- 26 Track 00- 28 Write Protect- 30 Read Data- 32 Side 1 Select- 34 Diskette