Chapter 6: Advanced Chassis Setup Replacing System Cooling Fans 1. Removing a system cooling fan: With the chassis cover removed, first unplug the fan cable corresponding to the failed fan. Then remove the fan housing from the chassis by depressing the locking tab and pulling the unit straight up (see Figure 6- 3). Take apart the fan housing to remove the fan from inside. 2. Installing a new system cooling fan: Replace the failed fan with an identical 9-cm, 12 volt fan (available from Supermicro). After the new fan has been installed, reassemble the fan housing and plug the housing back into its slot. You should hear it click into place when fully inserted.
Then plug the fan cable back into the header on the circuit board you removed it from. You should then wind the excess cable around the tabs on the fan housing to keep it out of the way. Check that the fan is working properly and that the LEDs on the control panel circuit board (Figure 6-2) and the front control panel have turned off. Finish by replacing the top panel of the chassis. Figure 6-3. System Cooling Fan Removal 6-5 Locking Tab