Supermicro SuperServer 8060 — Supermicro SuperServer 8060 User Manual PDF – 4U Quad Xeon Server Guide

Chapter 7: BIOS/Setup The BIOS will attempt to read the boot record from 1st, 2nd, 3rd and 4th boot device in the selected order until it is successful in reading the booting record. The BIOS will not attempt to boot from any device which is not selected as the boot device. This setting controls the action of the BIOS if all the selected boot devices failed to boot. The settings for this option are Yes and No. If Yes is selected, the BIOS will try to boot from the other boot devices that are present in the setup but not selected if all selected Boot Devices failed to boot.

If No is selected, the BIOS will not try to boot from the other boot devices when all selected boot devices failed to boot. Try Other Boot Devices Initialize I2O Devices The options for this setting are Yes and No. If Yes is selected, the BIOS will initialize I2O processor(s), I2O storage devices and provide INT13 support for I2O storage devices. If No is selected, the BIOS will not initialize I2O processor(s) and I2O storage devices. Initial Display Mode This option determines the display screen with which the POST is going to start the display. The options for this setting are BIOS and Silent . If selected as BIOS, the POST will start with the normal sign-on message screen.

If Silent is selected, the POST will start with the Supermicro screen . Display Mode at Add-On ROM Init The options for this setting are Force BIOS and Keep Current. If Force Bios is selected, the Add-on ROM will take control of the POST screen. Floppy Access Control The options for this setting are Read-Write and Read-Only. This option will be effective only if the device is accessed through BIOS. Hard Disk Access Control The options for this setting are Read-Write and Read-Only. This option will be effective only if the device is accessed through BIOS. S.M.A.R.T. for Hard Disks S.M.A.R.T.

(Self-Monitoring, Analysis and Reporting Technology) is a technology developed to manage the reliability of the hard disk by predict- ing future device failures. The hard disk needs to be S.M.A.R.T. capable. The options for this setting are Disabled and Enabled. Note: S.M.A.R.T. cannot predict all future device failures. S.M.A.R.T. should be used as a warning tool, not as a tool to predict the device reliability. 7-7