Supermicro SuperServer 8060 — Supermicro SuperServer 8060 User Manual PDF – 4U Quad Xeon Server Guide

S UPER S ERVER 8060 Manual Serial Port2 Mode The options for this setting are Normal , IrDA SIR-A,. IrDA SIR-B, ASKIR, Consumer and Raw IR. When set to anything but Normal, the IR Duplex Mode becomes available and can be set to either Half or Full . Serial Port2 Duplex Mode This setting is enabled by the selection made in the previ- ous Serial Port 2 Mode setting. This makes the IR Duplex Mode available, which can be set to either Half or Full . Onboard Parallel Port This setting specifies the base I/O port address of the parallel port on the motherboard. The options are Auto (AMIBIOS automatically determines the correct base I/O port address), Disabled, 378h , 278h and 38Ch.

Parallel Port Mode This setting specifies the parallel port mode. The options are Normal, Bi-Dir, EPP and ECP . When set to Normal, the normal parallel port mode is used. Use Bi-Dir to support bidirectional transfers. Use EPP (Enhanced Parallel Port) to provide asymmetric bidirectional data transfer driven by the host device. Use ECP (Extended Capabilities Port) to achieve data transfer rates of up to 2.5 Mbps. ECP uses the DMA protocol and provides symmetric bidirectional communication. Note: The Optimal default setting for this option is ECP and the Fail-Safe setting is Normal . EPP Version The options are Enabled and Disabled. Note: The Optimal and Fail-Safe default settings are N/A .

Parallel Port IRQ This setting specifies the IRQ to be used by the parallel port. The options are 5 and 7 . Parallel Port ECP DMA Channel This setting is only available if the parallel port mode is set to ECP. The options are 0, 1, 2, 3 , 5, 6 and 7. Onboard IDE This setting enables the IDE (Hard Disk Drive Controller) device(s) on the motherboard. The options are Enabled and Disabled. 7-18