Supermicro SuperServer E100-9APP — Supermicro SuperServer E100-9APP User's Manual PDF (Revision 1.0a)

SuperServer E100-9APP User's Manual Configure SATA as Select IDE to configure a SATA drive specified by the user as an IDE drive. Select AHCI to configure a SATA drive specified by the user as an AHCI drive. Select RAID to configure a SATA drive specified by the user as a RAID drive. The options are IDE, AHCI , and RAID. *If the item above "Configure SATA as" is set to AHCI, the following items will display: SATA Frozen Use this item to enable the HDD Security Frozen Mode. The options are Enabled and Disabled . SATA AHCI LPM Use this feature to enable the Link Power Management for SATA AHCI. The options are Disabled and Enabled .

Support Aggressive Link Power Management When this item is set to Enabled, the SATA AHCI controller manages the power usage of the SATA link. The controller will put the link in a low power mode during extended periods of I/O inactivity, and will return the link to an active state when I/O activity resumes. The options are Enabled and Disabled. SATA Port 0 - Port 5 This item displays the information detected on the installed SATA drive on the particular SATA port. Model number of drive and capacity Software Preserve Support Port 0 - Port 5 Hot Plug This feature designates this port for hot plugging.

Set this item to Enabled for hot-plugging support, which will allow the user to replace a SATA drive without shutting down the system. The options are Enabled and Disabled. Port 0 - Port 5 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The options are Enabled and Disabled . Port 0 - Port 5 SATA Device Type Use this item to specify if the connected SATA device is a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. *If the item above "Configure SATA as" is set to IDE, the following items will display: 42