Supermicro SuperServer E200-9AP — Supermicro SuperServer E200-9AP User's Manual (Revision 1.0) PDF Download

Chapter 2: Maintenance and Component Installation M.2 SSD The A2SAV-L supports one M.2 SSD of 120mm in length. Visit the Supermicro website for a current list of supported M.2 SSDs. Note: installing an M.2 SSD card will disable I-SATA0. Installing an M.2 SSD 1. Power down the system er as described in Section 2.1. 2. Access the motherboard by removing the chassis cover as described in Section 2.3. 3. Locate the M.2 slot (JMD1) and the screw mount (M2_SRW3) that secures it, as shown in Figure 2-5 below. 4. Insert the M.2 SSD into the slot at a slight upward angle. Note the two keys on the M.2 card and the slot to ensure that the SSD is installed with the correct side up. 5.

Secure the M.2 card by placing a screw in the screw mount. 6. Replace the chassis cover. 7. Plug the power cords into the rear of the power supply and power up the system. M2_SRW3 VGA JI2C2 JI2C1 JPAC1:AUDIO 2-3:DISABLE 1-2:ENABLE FP AUDIO JPL1 JPL2 USB0/1 HDMI/DP JI2C2 JI2C1 JPAC1 EDP1 1-2:ENABLE 2-3:DISABLE JPL2: JPL1: 1-2:ENABLE 2-3:DISABLE LAN2 LAN1 LAN1 LAN2 USB8/9 COM1 USB2/3(3.0) 2-3:DISABLE 1-2:ENABLE 2-3:DISABLE 1-2:ENABLE JI2C2: JI2C1:

M2_SRW3 DESIGNED IN USA A2SAV REV:1.02 BAR CODE FAN1 CPU SLOT1 PCI-E 2.0 X2 (IN X8) SRW2 CPU SRW1 1 2 M2_SRW1 JP1 JL1:CHASSIS INTRUSION JD1 JMP1 mSATA/mini PCIE JBT1 COM3 J1 JMD1 JSD1 SATA+ DOM POWER BT1 JL1 JGP1 USB6/7 I-SATA0 M-SATA3 M-SATA2 I-SATA1 SODIMM1(1.35V only) JSTBY1 JMD1 J7 J4 J5 USB5 M-SATA1 M-SATA0 JPV1 FAN2 C A LED2 C A LED1 C A LED3 USB4 COM2 JTPM1 JPH1 JPW1 JF1 2 1 JWD1 FF X RST PWR ON NMI X PWR LED LED HDD 1 NIC NIC 2 Figure 2-5. Installing an M.2 Solid State Device 19 JI --2 32C E1N : JI --2 32C E2N : 21 ::D SAABBLLEE 21 ::D SAABBLLEE I I M2_SRW3 CPU SLOT1 S PCI-E 2.0 X2 (IN S X8) M2_SRW1 JD1 JMD1 COM3 I-