SuperServer E200-9AP User's Manual SATA Mode Selection Use this item to select the mode for the installed SATA drives. The options are AHCI and RAID. Aggressive LPM (Link Power Management) Support When this item is set to Enabled, the SATA AHCI controller manages the power usage of the SATA link. The controller will put the link in a low power mode during extended periods of I/O inactivity, and will return the link to an active state when I/O activity resumes. The options are Enabled and Disabled. SATA Frozen Use thia feature to enable the HDD Security Frozen Mode. The options are Disabled and Enabled. SATA Port 0 ~ 1 Port Use this feature to enable of disable the specified SATA port.
The options are Disabled and Enabled . SATA Port Hot Plug This feature designates the SATA port specified for hot plugging. Set this item to Enabled for hot-plugging support, which will allow the user to replace a SATA disk drive without shutting down the system. The options are Enabled and Disabled. Spin Up Device When the value of an edge detect or the value of an image binary (pixel) of a device is from 0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence on this device. The options are Enabled and Disabled . SATA Device Type Use this item to specify if the SATA port specified by the user should be connected to a Solid State drive or a Hard Disk Drive.
The options are Hard Disk Drive and Solid State Drive. SATA Port DevSlp DEVSLP is a signal that is sent to a SATA disk drive to tell it to enter a very low power state. The options are Disabled and Enabled. Trusted Computing Security Device Support If this feature and the TPM jumper on the motherboard are both set to Enabled, onboard security devices will be enabled for TPM (Trusted Platform Module) support to enhance data integrity and network security. Reboot the system for a change on this setting to take effect. The options are Disable and Enable . 46