SuperServer E200-9B User's Manual TPM Header The JTPM1 header is used to connect a Trusted Platform Module (TPM). A TPM can securely store artifacts used to authenticate the platform. These artifacts can include passwords, certificates, or encryption keys. See the table below for pin definitions. 19 1 20 JTPM1 Pin Layout 2 Standby Power The Standby Power header is located at JSTBY1 on the motherboard. See the table below for pin definitions. 4-pin BMC External I 2 C Header A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect a cable to this header to use the IPMB I 2 C connection on your system. See the table below for pin definitions.
26 Trusted Platform Module Header Pin Definitions Pin# Definition Pin# Definition 1 LCLK 2 GND 3 LFRAME# 4 No Pin 5 LRESET# 6 +5V (X) 7 LAD3 8 LAD2 9 3.3V 10 LAD1 11 LAD0 12 GND 13 SMB CLK4 (X) _ 14 SMB DAT4 (X) _ 15 P3V3 STBY _ 16 SERIRQ 17 GND 18 GND 19 P3V3 STBY _ 20 LDRQ# (X) Standby Power Pin Definitions Pin# Definition 1 +5V Standby 2 Ground 3 No Connection External I2C Header Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection