Supermicro SuperServer E200-9B — Supermicro SuperServer E200-9B User & Service Manual PDF

SuperServer E200-9B User's Manual VGA Enable/Disable JPG1 allows you to enable or disable the VGA port using the onboard graphics controller. The default setting is Enabled. Manufacturing Mode Select Close JPME2 to bypass SPI flash security and force the system to use the Manufacturing Mode, which will allow you to flash the system firmware from a host server to modify system settings. See the table below for jumper settings. PCI-E Slot SMB Enable (JI 2 C1/JI 2 C2) JI 2 C1 and JI 2 C2 are used to enable PCI-E SMB (System Management Bus) support to improve system management for the onboard PCI-E slot. Watch Dog JWD1 controls the Watch Dog function.

Watch Dog is a monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note: When Watch Dog is enabled, the user needs to write their own application software to disable it.

30 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Manufacturing Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal (Default) Pins 2-3 Manufacturing Mode SMB to PCI-E Slots (JI2C1/JI2C2) Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled