SuperServer E300-8D User's Manual Control Panel JF1 contains header pins for various control panel connections. See the figure below for the pin locations and definitions of the control panel buttons and LED indicators. All JF1 wires have been bundled into a single cable to simplify this connection. Make sure the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the control panel PCB board.
Power On LED (Control signal) 16 15 3.3V HDD LED (Activity signal) 3.3V Standby NIC1 LED (Ground) 3.3V Standby OH/Fan Fail LED (Ground) NIC2 LED (Ground) 3.3V Standby UID LED Power Fail LED (Ground) 3.3V (Ground) (Ground) Reset Button (Data signal) Power Button (Data signal) 2 1 Figure 4-1. JF1: Control Panel Pins Power Button The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both pins will power on/off the system. This button can also be configured to function as a suspend button with a setting in the BIOS. To turn off the power when the system is in suspend mode, press the button for 4 seconds or longer.
Reset Button The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset switch on the computer case. 32 Power Button Pin Definitions (JF1) Pin# Definition 1 Signal 2 Ground Reset Button Pin Definitions (JF1) Pin# Definition 3 Reset 4 Ground