Chapter 3 Motherboard Connections VGA Enable/Disable Jumper JPG1 allows you to enable or disable the VGA port using the onboard graphics controller. The default setting is Enabled. PCI-E Slot SMB Enable I2C1/I2C2 are used to enable PCI-E SMB (System Management Bus) support to improve system management for the onboard PCI-E slot. Watch Dog JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS.
The default setting is Reset. Note: When Watch Dog is enabled, the user must write their own application software to disable it. BMC Enabled JPB1 allows you to enable the BMC (Baseboard Management Control) chip and the onboard IPMI connection for debugging purpose only. After the BMC is disabled, IPMI health and remote management functions are no longer supported. Note: Keep BMC enabled to make sure that the platform operates reliably with the health monitor.
37 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled SMB to PCI-E Slots (JI2C1/JI2C2) Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled (Default) Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled BMC Enabled Jumper Settings Pin# Definition 1-2 Enabled (Default) 2-3 Disabled