Supermicro 5029P-E1CTR12L — Supermicro SuperStorage 5029P-E1CTR12L User's Manual PDF Download

Chapter 3: Maintenance and Component Installation 3.4 Chassis Components Hard Drives Your server may or may not have come with hard drives installed. Up to twelve 3.5" hard drives are supported by the chassis. The SAS/SATA drives are mounted in drive carriers to simplify their installation and removal from the chassis. (Both procedures may be done without removing power from the system.) Removing a Hot-Swap Drive Carrier 1. Push the release button on the carrier. 2. Swing the handle fully out. 3. Grasp the handle and use it to pull the drive carrier out of its bay. Mounting a Drive in a Drive Carrier 1.

To add a new drive, install it into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 2. Secure the drive to the carrier with the screws provided, then push the carrier completely into the drive bay. You should hear a *click* when the drive is fully inserted. This indicates that the carrier has been fully seated and connected to the midplane, which automatically makes the power and logic connections to the hard drive. Figure 3-4. Removing a Hard Drive Carrier Note: Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers.

For information on recommended HDDs, visit the Supermicro website at http://www. supermicro.com/products/nfo/storage.cfm 35