Supermicro 5049P-E1CTR36L — Supermicro SuperStorage 5049P-E1CTR36L User's Manual PDF

Chapter 3: Maintenance and Component Installation Installing PCI Expansion Cards The 5049P-E1CTR36L can accommodate up to four PCI expansion cards in the PCI expansion slots on the serverboard. Installing an Add-on Card 1. Begin by removing the shield for the PCI slot you wish to populate. Make sure that the card you are installing is supported by the slot (see table below). 2. Fully seat the card into the slot, pushing down with your thumbs evenly on both sides of the card. 3. Finish by using a screw to secure the top of the card shield to the chassis.

The PCI slot shields protect the serverboard and its components from EMI and aid in proper ventilation, so make sure there is always a shield covering each unused slot. Motherboard Battery The motherboard uses non-volatile memory to retain system information when system power is removed. This memory is powered by a lithium battery residing on the motherboard. Replacing the Battery Begin by removing power from the system as described in section 3.1. 1. Push aside the small clamp that covers the edge of the battery. When the battery is released, lift it out of the holder. 2. To insert a new battery, slide one edge under the lip of the holder with the positive (+) side facing up.

Then push the other side down until the clamp snaps over it. Note: Handle used batteries carefully. Do not damage the battery in any way; a damaged battery may release hazardous materials into the environment. Do not discard a used battery in the garbage or a public landfill. Please comply with the regulations set up by your local hazardous waste management agency to dispose of your used battery properly. Figure 3-3. Installing the Onboard Battery Warning: There is a danger of explosion if the onboard battery is installed upside down (which reverses its polarities). This battery must be replaced only with the same or an equivalent type recommended by the manufacturer (CR2032). 36