Supermicro 5049P-E1CTR36L — Supermicro SuperStorage 5049P-E1CTR36L User's Manual PDF

SuperStorageSystem 5049P-E1CTR36L User's Manual 3.4 Chassis Components Hard Drives Your system may or may not have come with hard drives installed. Up to thirty-six 3.5" hard drives are supported by the chassis (24 in front and 12 in the rear of the chassis). The hard drives are mounted in drive carriers to simplify their installation and removal from the chassis. (Both procedures may be done without removing power from the system.) Removing a Hot-Swap Drive Carrier 1. Push the release button on the carrier. 2. Swing the handle fully out. 3. Grasp the handle and use it to pull the drive carrier out of its bay. Mounting a Drive in a Drive Carrier 1.

To add a new drive, install it into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 2. Secure the drive to the carrier with the screws provided, then push the carrier completely into the drive bay. You should hear a *click* when the drive is fully inserted. This indicates that the carrier has been fully seated and connected to the midplane, which automatically makes the power and logic connections to the hard drive. Figure 3-4. Removing a Hard Drive Carrier Note: Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers.

For information on recommended HDDs, visit the Supermicro website at http://www. supermicro.com/products/nfo/storage.cfm 37