Chapter 3: Maintenance and Component Installation Figure 3-5. Mounting a Drive in a Carrier Caution: Except for short periods of time, do not operate the server without the chassis cover in place. The cover must be in place to allow proper airflow and prevent overheating. Hard Drive Backplane The hard drives plug into a backplane that provides power, drive ID and bus termination. The supplied RAID controller provides hot-swap capability with drive state indication. The backplane is already preconfigured, so no jumper or switch configurations are required.
Installing Optional Fixed Hard Drives Optional brackets for the SC847BE1C chassis may be used to install either one 3.5" fixed hard drive or two 2.5" fixed hard drives. These brackets install under the serverboard tray. Each chassis can accommodate up to two of these brackets to support up to two 3.5" hard drives or up to four 2.5" hard drives (tray p/n: MCP-220-84701-0N). Installing a 3.5" Hard Drive into the Bracket 1. Align the four washers and screws with the holes in the hard drive and the holes in the bracket. 2. Secure the hard drive to the bracket using the screws and washers provided. 3. See the instructions below for Installing the bracket onto the chassis.
Installing Two 2.5" Hard Drives into the Bracket 1. Align the eight external tooth washers and eight screws with the holes in the hard drive and the holes in the bracket. 2. Secure the hard drive to the bracket using the screws and washers provided. 3. See the instructions below for installing the bracket onto the chassis. Installing the Bracket onto the Chassis 1. Align the holes in the bracket with the chassis standoffs. 2. Secure the bracket using the screw provided. 38