Chapter 4: Motherboard Connections Disk-On-Module Power Connector Two power connectors for SATA DOM (Disk-On-Module) devices are located at JSD1/JSD2. Connect appropriate cables here to provide power support for your Serial Link DOM devices. TPM/Port 80 Header A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support and Port 80 connection. Use this header to enhance system performance and data security. Refer to the table below for pin definitions. Please go to the following link for more information on the TPM: http://www.supermicro.com/manuals/other/TPM.pdf . Standby Power The Standby Power header is located at JSTBY1 on the motherboard.
You must have a card with a Standby Power connector and a cable to use this feature. Refer to the table below for pin definitions. Internal Speaker/Buzzer The Internal Speaker/Buzzer (SP1) is used to provide audible indications for various beep codes. Refer to the table below for pin definitions.
45 DOM Power Pin Definitions Pin# Definition 1 5V 2 Ground 3 Ground Trusted Platform Module Header Pin Definitions Pin# Definition Pin# Definition 1 +3.3V 2 SPI CS# _ 3 RESET# 4 SPI MISO _ 5 SPI CLK _ 6 GND 7 SPI MOSI _ 8 9 +3.3V Stdby 10 SPI IRQ# _ Standby Power Pin Definitions Pin# Definition 1 +5V Standby 2 Ground 3 No Connection Internal Buzzer Pin Definitions Pin# Definition 1 Pos (+) Beep In 2 Neg (-) Alarm Speaker