Chapter 4: Motherboard Connections Power LED/Speaker Pins 1-3 of JD1 are used for power LED indication, and pins 4-7 are for the speaker. Please note that the speaker connector pins (4-7) are used with an external speaker. If you wish to use the onboard speaker, you should close pins 6-7 with a cap. Refer to the tables below for pin definitions. Overheat/Fan Fail LED Header The JOH1 header is used to connect an LED indicator to provide warnings of chassis overheating and fan failure. This LED will blink when a fan failure occurs. Refer to the tables below for pin definitions.
SATA and SAS Ports The X11SPH-NCTF has eight SATA 3.0 ports (I-SATA0~3, I-SATA4~7) supported by the Intel PCH C622 chipset. These SATA ports support RAID 0, 1, 5, and 10. There are also two S-SATA ports (S-SATA0, S-SATA1) that include SATA DOM power. SATA ports provide serial- link signal connections, which are faster than the connections of Parallel ATA. In addition, the X11SPH-NCTF has eight SAS 3.0 ports (L-SAS0~7) that are supported by the LSI 3008 controller. Refer to the table below for pin definitions. Note : For more information on the SATA HostRAID configuration, please refer to the Intel SATA HostRAID user's guide posted on our website at http://www.supermicro.com.
NVMe Slots Two NVM Express slots are located at JNVME1 and JNVME2 on the motherboard. Use these slots to attach high-speed PCI-E storage devices. 47 Speaker Connector Pin Definitions Pin# Signal 4 P5V 5 Key 6 R SPKPIN N _ _ 7 R SPKPIN _ PWR LED Connector Pin Definitions Pin# Signal 1 JD1 PIN1 _ 2 FP PWR LED _ _ 3 FP PWR LED _ _ Overheat LED header Status State Definition Solid Overheat Blinking Fan Fail Overheat LED Pin Definitions Pin# Signal 1 Pull high to +3.3V power through 330-ohm resistor 2 OH Active