Chapter 5: Advanced Serverboard Setup Chassis Intrusion The Chassis Intrusion header is des- ignated JL1. Attach an appropriate cable from the chassis to inform you of a chassis intrusion when the chas- sis is opened Wake-On-LAN The Wake-On-LAN header is desig- nated JWOL on the serverboard. See the table on the right for pin defi ni- tions. You must also have a LAN card with a Wake-On-LAN connector and cable to use this feature. Wake-On-Ring The Wake-On-Ring header is des- ignated JWOR. This function allows your computer to receive and be "awakened" by an incoming call when in the suspend state. See the table on the right for pin defi nitions.
You must also have a WOR card and cable to use this feature. Power Supply Fail LED Connect a cable from your power supply to the PSF header to provide warning of power supply failure. This warning signal is passed through the PWR_LED pin to indicate of a power failure on the chassis. See the table on the right for pin defi nitions. Note: This feature is only available when us- ing Supermicro redundant power supplies. LAN1/2 (Ethernet Ports) Two Ethernet ports (designated LAN1 and LAN2) are located beside the par- allel port on the I/O backplane. These ports accept RJ45 type cables.
5-17 Chassis Intrusion Pin Defi nitions (JL1) Pin# Defi nition 1 Intrusion Input 2 Ground Wake-On-LAN Pin Defi nitions (JWOL) Pin# Defi nition 1 +5V Standby 2 Ground 3 Wake-up Wake-On-Ring Pin Defi nitions (JWOR) Pin# Defi nition 1 Ground (Black) 2 Wake-up PWR Supply Fail LED Pin Defi nitions (PSF) Pin# Defi nition 1 PWR 1: Fail 2 PWR 2: Fail 3 PWR 3: Fail 4 Signal: Alarm Reset