Super Micro Computer, Inc. 7045A-WT — Super Micro 7045A-WT User Manual: Comprehensive Guide for System Integrators and Technicians

Chapter 5: Advanced Serverboard Setup Alarm Reset If three power supplies are installed, the system can notify you when any of the three power modules fail. Connect JAR to a micro-switch to enable you to turn off the alarm that is activated when a power module fails. See the table on the right for pin defi nitions. Power SMB (I 2 C) Connector The power SMB (I 2 C) connector is used to monitor the status of the power supply, fan and system tem- perature. See the table on the right for pin defi nitions. Overheat LED/Fan Fail (JOH1) The JOH1 header is used to connect an LED to provide warning of chassis overheating. This LED will blink to in- dicate a fan failure.

Refer to the table on right for pin defi nitions. ATX PS/2 Keyboard and PS/2 Mouse Ports The ATX PS/2 keyboard and the PS/2 mouse are located beside the USB0/1 ports. The mouse port is above the keyboard port. See the table on the right for pin defi nitions.

5-19 Alarm Reset Header Pin Defi nitions (JAR) Pin Setting Defi nition Pin 1 Ground Pin 2 +5V PWR SMB Header Pin Defi nitions (J17) Pin# Defi nition 1 Clock 2 Data 3 PWR Fail (Input from PS to MB) 4 Ground 5 +3.3V OH/Fan Fail LED States State Message Solid Overheat Blinking Fan Fail Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 5vDC 2 OH Active PS/2 Keyboard and Mouse Port Pin Defi nitions (J28) Pin# Defi nition 1 Data 2 NC 3 Ground 4 VCC 5 Clock 6 NC