S uper W orkstation 7045A-WT User's Manual Compact Flash Card PWR Connector A Compact Flash Card Power Con- nector is located at JWF1. For the Compact Flash Card to work properly, you will need to enable with JCF1 and connect a Compact Flash Card power cable to JWF1 fi rst. CD Header A 4-pin CD header (CD1) and a Front Panel Audio header (Audio FP) are included on the serverboard. These headers allow you to use the onboard sound for audio CD playback. Connect an audio cable from your CD drive to the CD header that fi ts your cable's connector. Only one CD header can be used at any time. See the tables at right for pin defi nitions.
(See below for the Audio FP header.) Front Panel Audio Control When front panel headphones are plugged in, the back panel audio output is disabled. This is done through the FP Audio header (Audio FP). If the front panel interface card is not connected to the front panel audio header, jumpers should be installed on pin pairs 1-2, 5-6, and 9-10 of the Audio FP header. If these jumpers are not installed, the back panel line out connector will be disabled, and pin 1 of the microphone in will be left fl oating, which can lead to excessive back panel microphone noise and crosstalk. See the table at right for pin defi nitions.
5-20 Compact Flash Card PWR Connector (JWF1) Jumper Defi nition On Compact Flash Power On Off Compact Flash Power Off CD1 Pin Defi ni- tions Pin# Defi nition 1 Left 2 Ground 3 Ground 4 Right Front Panel Audio Pin Defi nitions (Audio FP) Pin# Defi nition 1 MIC L _ 2 Audio Ground 3 MIC R _ 4 FP Audio Detect 5 Line 2 R _ _ 6 Ground 7 FP Jack Detect _ 8 Key 9 Line 2 L _ _ 10 Ground