Supermicro SuperWorkstation 7048GR-TR — Supermicro SuperWorkstation 7048GR-TR User's Manual (Rev 1.0c) PDF Download

S UPER W ORKSTATION 7048GR-TR User's Manual 5-5 Installing Memory Caution: Exercise extreme care when installing or removing DIMM modules to prevent damage. Installing Memory Modules 1. Insert the desired number of DIMMs into the memory slots, starting with P1- DIMMA1. For best memory performance, please install memory modules of the same type and same speed on the memory slots as indicated on the tables below. 2. Insert each DIMM module vertically into its slot. Pay attention to the notch along the bottom of the module to avoid installing incorrectly (see Figure 5-3). 3. Gently press down on the DIMM module until it snaps into place in the slot. Repeat for all modules.

Notch Notch To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom. Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Note: Notch should align with the receptive key point on the slot. Release Tab Release Tab Top View of Slot Figure 5-2. DIMM Installation The X10DRG-Q serverboard supports up to 1 TB of 288-pin registered (RDIMM) DDR4 ECC 1333/1600/1866/2133 MHz in 16 slots. DIMM sizes up to 64GB @ 1.2V. Can be used. See the following table for memory installation.

For the latest memory updates, please refer to the Supermicro website. Memory Support 5-8