S UPER W ORKSTATION 7048GR-TR User's Manual Manufacturer Mode Select Close pins 2 and 3 of Jumper JPME2 to bypass SPI flash security and force the system to operate in the Manufacturer mode, which will allow the user to flash the system firmware from a host server for system setting modifications. See the table on the right for jumper settings. I 2 C Bus to PCI-Exp. Slots Use Jumpers JI 2 C1 and JI 2 C2 to connect the System Management Bus (I 2 C) to PCI-Express slots to improve PCI performance. These two jumpers must be set at the same time. The default setting is on pins 2-3 to disable the connection for normal operations. See the table on the right for jumper settings.
Audio Enable Jumper JPAC1 allows the user to enable the front audio (AUDIO_FP) connector. The default setting is on pins 1-2 to enable the connection. See the table on the right for jumper settings. 5-24 ME Mode Select Jumper Settings Jumper Setting Definition 1-2 Normal (Default) 2-3 Manufacture Mode I2C for PCI-E slots Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled (Default) FP Audio Enable Jumper Settings Jumper Setting Definition 1-2 Enabled (Default) 2-3 Disabled