From version 2.x.xxxx.x | Licenses ◦With TwinCAT Package Manager: at least version 3.1.4026 (see Installing TwinCAT 3.1 Build 4026 ) ◦With Setup: version 3.1.4024.7 or later Runtime PC TwinCAT 3 XAR, at least version 3.0 The operating system of the runtime PC is not relevant TwinCAT Package Manager: Installation (TwinCAT 3.1 Build 4026) Detailed instructions on installing products can be found in the chapter Managing TwinCAT software in the TwinCAT 3.1 Build 4026 installation instructions . Install the following workload to be able to use the product: In the UI: TE1410 | TwinCAT 3 Interface for MATLAB®/Simulink® In the command line:
tcpkg install TE1410.InterfaceForMATLABSimulink.XAE The TE1410 product is installed in the TwinCAT folder structure, i.e. it is separate from the MATLAB ® installation. To use the functions from TE1410 in your version of MATLAB ® , you must register the TE1410 installation with your MATLAB ® installation. To do this, perform the steps listed below. The procedure described below is also necessary after updating the TE1410 product. ь The system requirements (MATLAB ® PC) have been met. ь The TE1410 workload is installed (see Managing TwinCAT software ). ь You have administrator rights on your system. Without administrator rights, you must perform Step 2 after every (re)start of MATLAB ® . 1.
Launch MATLAB ® with administrator rights. р You can then use the functions of the TE1410 product in your MATLAB ® installation. 2. Run the command below at the MATLAB ® command line to start the installation script. run(getenv("TWINCAT3DIR") + "..\Functions\TE14xx-ToolsForMatlabAndSimulink\SetupTE14xx.p") Setup: Installation (TwinCAT 3.1 Build 4024) ь The system requirements (MATLAB ® PC) have been met. ь You have administrator rights on your system. Without administrator rights, you must perform Step 4 1. Start TwinCAT Tools for MATLAB ® and Simulink ® setup to install the TE1410. after every (re)start of MATLAB ® . 2. Follow the instructions in the setup window.
р The TE1410 is installed within the TwinCAT folder structure, which means that the TE1410 installation is separate from your MATLAB ® installation. To use the functions from TE1410, you must register the TE1410 installation with your MATLAB ® installation. To do this, perform the following steps. These steps are also necessary after updating the TE1410. 3. Launch MATLAB ® with administrator rights. 4. Run the command below at the MATLAB ® command line to start the installation script. р You can then use the functions of the TE1410 product in your MATLAB ® installation.
run(getenv("TWINCAT3DIR") + "..\Functions\TE14xx-ToolsForMatlabAndSimulink\SetupTE14xx.p") 3.3 Licenses | Licenses To use the functions of the TE1410 interface for MATLAB ® /Simulink ® , a TE1410 license is required on the MATLAB ® PC . TE1410 26 Version: 1.3.1